Music Gear Forums

Check all music gear forums at once glance

I got a job!

I know this is not necessarily the right place to post this, but I couldn’t figure which would be better. anyhow, I GOT A JOB!!! A few months ago, I asked a recording engineer in town who I’ve done projects in town with in the past if I could intern under him, he said yes, but it took until last week that I was actually in the studio. Half way through the sessions, he told me that, the person in control room B was going on a 5 month tour, and that he was going to rent it out to somebody and couldn’t find anybody.

By rene-lemieux (Home Recording)

Read more

Rnla vs pbc-6a

i know similar threads have been put up before, but no direct comparisons of the two… so if you were to buy a RNLA or a PBC-6A for your main tracking of vocals on your one “golden channel” which one would you get if you were on a budget?

By damien907 (Gearslutz.com)

Read more

Pre-amp for shure sm 7b

Hey folks! First of all, I have to thank everybody on the board who’s helped me to make my decision towards a decent studio microphone for the sake of brevity and my future recordings ;D Now, I’m looking for a pre-amp that’s gonna make good use both of the sm 7b and rode nt1-a.

By atticmike (Gearslutz.com)

Read more

Advice on removing HF harshness from vocal

Looking for some advice on removing the harshness in the HF region of a vocal. It sounds almost like distortion, not pleasant at all. Is this the mic being pushed too hard?

By blacklight_uk (Gearslutz.com)

Read more

Advice on removing HF harshness from vocal

Looking for some advice on removing the harshness in the HF region of a vocal. It sounds almost like distortion, not pleasant at all

By blacklight_uk (Gearslutz.com)

Read more

New Romplers?

I’m thinking of adding a new Rompler in the future. hidz I’ve got pretty much all crazy methods of synthesis covered with some cool toys, but the certain sound of the Rompler is missing.

By Entrainer (Gearslutz.com)

Read more

New Romplers?

I’m thinking of adding a new Rompler in the future.

By Entrainer (Gearslutz.com)

Read more